NISSAN 2012 LEAF - Owner's Manual - Manual (Page 197)

2-60 Instruments and controls
PROGRAMMING HomeLink ® FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting after
2 seconds. To program your hand-held trans-
mitter to HomeLink
® , continue to push and hold
the HomeLink ® button (see steps 2 through 4
under “Programming HomeLink ® ” earlier in this
section) while you push and re-push (“cycle”)
your hand-held transmitter every 2 seconds until
the indicator light flashes rapidly (indicating
successful programming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener com-
ponents.
OPERATING HomeLink
®
UNIVER-
SAL TRANSCEIVER
The HomeLink ® Universal Transceiver (once
programmed) may now be used to activate the
garage door, etc. To operate, simply push the
appropriate programmed HomeLink
® Universal
Transceiver button. The red indicator light will
illuminate while the signal is being transmitted.
PROGRAMMING TROUBLE-DIAG-
NOSIS
If HomeLink ® does not quickly learn the hand-
held transmitter information, perform the follow-
ing steps.
. Replace the hand-held transmitter batteries
with new batteries.
. Position the hand-held transmitter with its
battery area facing away from the
HomeLink
® surface.
. Push and hold both the HomeLink ® and
hand-held transmitter buttons without inter-
ruption.
. Position the hand-held transmitter 2 to 5
inches (50 to 127 mm) away from the
HomeLink
® surface. Hold the transmitter in
that position for up to 15 seconds. If
HomeLink
® is not programmed within that
time, try holding the transmitter in another
position while keeping the indicator light in
view at all times.
If you continue to have programming difficulties,
please contact the NISSAN Consumer Affairs
Department. The phone numbers are located in
the Foreword of this Owner’s Manual.
CLEARING PROGRAMMED INFOR-
MATION
Individual buttons cannot be cleared, however to
clear all programming, push and hold the two
outside buttons and release them when the
indicator light begins to flash (in approximately
20 seconds).
REPROGRAMMING A SINGLE
HomeLink
®
BUTTON
To reprogram a HomeLink ® Universal Transcei-
ver button, perform the following procedure.
1. Push and hold the preferred HomeLink ®
button. Do not release the button until step
4 has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
hand-held transmitter 2 to 5 in (50 to 127
mm) away from the HomeLink
® surface.
3. Push and hold the hand-held transmitter
button.
4. The HomeLink
®
indicator light will flash, first
slowly and then rapidly. When the indicator
light begins to flash rapidly, release both
buttons.
The HomeLink ® Universal Transceiver button
has now been reprogrammed. The new device
can be activated by pushing the HomeLink
®