First drive features – NISSAN 2015 Murano - Quick Reference Guide User Manual

Page 12

Advertising
background image

To view detailed instructional videos regarding these and other features,

please go to www.nissanownersinfo.mobi.

10

REMOTE ENGINE START* (if so equipped)
The remote start operating range is approximately 200 ft (60 m) from the vehicle. The

effective operating range may be shorter if there are walls, strong radio wave sources
near the operating location or other obstructions between the key and the vehicle.

For the remote start to function, the vehicle must be in P (PARK) with the ignition

off and all doors must be closed and locked. Please see your Owner’s Manual for
additional information.

To start your vehicle remotely:
1. Press the button

3

to lock all doors.

2. Within 5 seconds, press and hold the engine start button

2

for at least 2 seconds.

The engine will start, and the parking lights will turn on.
Automatic climate control system will begin heating or cooling the vehicle depending

on the outside (ambient) temperature, cabin (in-car) temperature and the last user
mode. During this period, the climate control display and buttons
will be inoperable until the ignition switch is turned on.

The engine will run for 10 minutes and then turn off.
Repeat steps 1 through 2 to extend the time for an additional

10-minute period. Remote Start can only be activated for a maximum
of 20 minutes.

• After two remote starts, the ignition switch must be cycled before

the remote start can be used again.

• To cancel remote start, press the button

2

.

To start driving, depress the brake pedal and

push the ignition switch START/STOP button.

*Laws in some communities may restrict the use of remote starters.
Check local regulations before using this feature.

LOCKING AND UNLOCKING THE VEHICLE
The operating range of the I-Key is within 31.5 in

(80 cm) from each request switch.

To lock the vehicle, either push the door handle request switch

1

once or press the

button

3

on the key fob.

To unlock the vehicle, perform one of the following procedures:
• Push either door handle request switch

1

once to unlock the corresponding door.

Press the door handle request switch

1

again within 1 minute to unlock all doors, or

• Press the button

4

on the key fob to unlock the driver’s side door. Press the

button

4

again within 1 minute to unlock all doors.

The I-Key can also be used to activate the panic alarm by pressing and holding the

button

5

for 1 second. Once activated, the panic alarm and headlights will stay on for

a period of time.

2
3

5

1

FIRST DRIVE FEATURES

4

1705374_15a_Murano_QRG_091214b.indd 10

9/12/14 10:46 AM

Advertising