NISSAN 2015 Murano - Quick Reference Guide - Manual (Page 14)

To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi. 12
AUTOMATIC DRIVE POSITIONER (if so equipped)
Two positions for the driver’s seat, steering column
(if so equipped) and outside mirrors can be stored
in the automatic drive positioner memory.
Follow this procedure to set the memory positions:
• Push the Ignition Switch to the ON or ACC
position. (The vehicle should be stopped while
setting the memory.)
• Adjust the driver’s seat, steering column (if so equipped) and outside mirrors to the
desired positions using the adjusting switches for each feature.
• Push the SET switch and within 5 seconds push the memory switch (1 or 2).
• The indicator light for the memory switch you select will illuminate for approximately
5 seconds, and a chime will sound when memory is stored.
• The driver’s seat, steering column (if so equipped) and outside mirror positions are now
set to your preferences.
These memorized positions can also be linked to your NISSAN Intelligent Key ® .
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
REAR SEAT ADJUSTMENTS
FOLDING DOWN THE REAR SEAT
To fold the seats flat, release the connector tongue
of the rear center seat belt from the buckle then
store the connector and seat belt tongues in the
retractor base on the ceiling
1 .
Fold the seatback forward using either the pull
strap 2 , located on the outside edge of the rear
seat, or the release lever 3
in the cargo area.
To raise the seatback manually, lift up each
seatback and push it to the upright position until it
is latched.
To raise the seatback automatically (if so
equipped), push and hold the power seatback
switch located in the cargo area
4
or the corresponding seat
switch on the lower side of the instrument panel 5 .
• A beep sounds once and the seatback begins to move automatically.
• A beep sounds twice when the seatback is fully returned to the upright seating position.
RECLINING THE REAR SEATS
Brace the back of the seat with your arm while pulling on the strap. The seatback will
release quickly.
Pull the reclining strap 2 , and move the seatback to the desired angle.
Release the reclining strap after positioning the seat at the desired angle.
For more information, refer to the “Safety – Seats, seat belts and supplemental restraint system (section 1)” of
your Owner’s Manual.
4
2 1
3
5
FIRST DRIVE FEATURES
1705374_15a_Murano_QRG_091214b.indd 12 9/12/14 10:46 AM