NISSAN 2014 Pathfinder Hybrid - Dismantling Guide - Manual (Page 37)

4-1 Jump Starting Procedures
NOTE:
Jumper cable connections under the hood of the Pathfinder HYBRID are not connected
directly to a battery. They are connected to chassis ground and a fuse box terminal. Refer
to the following instructions and the above illustration.
1. Locate the fuse box behind the engine air cleaner.
2. Push the tab in and lift up
○
A to remove the fuse box cover and expose the remote positive battery
terminal
○
B .
3. If the booster battery is in another vehicle, position the two vehicles to bring their batteries near
each other.
DO NOT allow the two vehicles to touch.
4. Apply the parking brake. Move the selector lever the P (Park). Switch off all unnecessary electrical
systems (lights, heater, air conditioner, etc.).
5. Remove vent caps on the battery (if so equipped) of the vehicle with battery for booster. Cover
the battery with an old cloth
○
F to reduce explosion hazard.
6. Connect jumper cables in the sequence as illustrated (
○
B
→
○
C
→
○
D
→
○
E ).
• Always connect positive (+) to positive (+) and negative (-) to body ground (for example,
as illustrated), not to the 12V battery.
• Make sure the jumper cables do not touch moving parts in the engine compartment and
that the cable clamps do not contact any other metal.
F
A
E
D
B
B
+
C
+
Cloth
Vehicle being jump started
Vehicle with
battery for
booster
AAYIA0072GB
DG–37