NISSAN 2012 Quest - Owner's Manual - Manual (Page 243)

Black plate (240,1)
[ Edit: 2011/ 10/ 27 Model: E52-D ]
4-60 Monitor, heater, air conditioner, audio, phone and voice recognition systems
Audio main operation
The audio system operates when the ignition
switch is in the “ACC” or “ON” position.
POWER button:
To turn on the audio system, push the POWER
button.
. The system will turn on in the mode, (radio or
CD) which was used immediately before the
system was turned off.
. If there is no CD loaded, the radio will be
turned on.
To turn off the audio system, push the POWER
button.
Volume control:
To control the volume, turn the VOLUME control
dial.
. Turn the dial clockwise to make the sound
louder.
. Turn the dial counterclockwise to make the
sound quieter.
AUDIO button:
To change the audio settings, push the AUDIO
button to select the mode while the CD or radio
is on.
Push the AUDIO button until the desired mode
appears on the display.
The display will change as follows.
BASS ? TREBLE ? FADE ? BALANCE ?
BEEP
Push the SEEK/TRACK/FILE button or TUNE/
FF·REW/FOLDER button to adjust the audio
settings.
BASS:
(−) to decrease / (+) to increase
TREBLE:
(−) to decrease / (+) to increase
FADE:
(F) to front fade / (R) to rear fade
BALANCE:
(R) to right balance / (L) to left balance
BEEP:
When this item is turned on, a beep will sound
each time a button is operated.
Once the audio settings are set to the desired
level, push the AUDIO button repeatedly until
the radio or CD display appears.
If the audio settings mode is unchanged for
approximately 5 seconds, the audio settings
mode will automatically return to the normal
mode.
Push the DISP button or SCRL button to return
to the normal mode.
button:
Clock display on/off:
Push the CLOCK button for less than 1.5
seconds to turn the clock on or off.
Clock adjustment:
1. Push and hold the CLOCK button until the
clock display starts to flash.
2. Push the SEEK/TRACK/FILE button to
adjust the hours.
3. Push the TUNE/FF·REW/FOLDER button to
adjust the minutes.
4. Push the CLOCK button again or push DISP
button or SCRL button to exit the clock set
mode.
If the clock set mode is unchanged for
approximately 10 seconds, the system will
automatically exit the clock set mode.