NISSAN 2012 Quest - Owner's Manual - Manual (Page 42)

Black plate (39,1)
[ Edit: 2011/ 10/ 27 Model: E52-D ]
Stowing 3rd row center seat belt:
When folding down the 3rd row seat, the 3rd
row center seat belt can be retracted into a
stowed position as follows:
1. Hold the connector tongue *
1 so that the
seat belt does not retract suddenly when the
tongue is released from the connector
buckle. Release the connector tongue by
inserting a suitable tool such as key
*
A into
the connector buckle.
2. Insert the seat belt tongue into the retractor
base first *
2 .
3. Then secure the connector tongue into the
retractor base *
3 .
WARNING
Do not unfasten the 3rd row center seat
belt connector except when folding
down the rear seat.
SSS1165
Attaching 3rd row center seat belt:
Always be sure the 3rd row center seat belt
connector tongue and connector buckle are
attached. Disconnect only when folding down
the 3rd row seat.
To connect the buckle:
1. Pull out the connector tongue from the
retractor base *
1 .
2. Pull out the seat belt tongue from the
retractor base *
2 .
3. Pull the seat belt and secure the connector
buckle until it clicks *
3 .
The center seat belt connector tongue and
buckle are indicated by the ! and ~ mark.
The center seat belt connector tongue can be
attached only into the 3rd row center seat belt
connector buckle.
To fasten the seat belt, see “Fastening the seat
belts” (P.1-20).
WARNING
. When attaching the 3rd row center
seat belt connector, be certain that
the seatbacks are completely se-
cured in the latched position and
the 3rd row center seat belt con-
Safety — Seats, seat belts and supplemental restraint system 1-23