NISSAN 2015 Sentra - Owner's Manual - Manual (Page 355)

NOTE:
The headlight is a semi-sealed beam type
which used a replaceable headlight (halo-
gen) bulb. They can be replaced from inside
the engine compartment without removing
the headlight assembly.
CAUTION
● Aiming is not necessary after replacing
the bulb. When aiming adjustment is
necessary, contact a NISSAN dealer.
● Do not leave the headlight assembly
open without a bulb installed for a long
period of time. Dust, moisture, smoke,
etc. entering the headlight body may
affect bulb performance. Remove the
bulb from the headlight assembly just
before a replacement bulb is installed.
● Only touch the base when handling the
bulb. Never touch the glass envelope.
Touching the glass could significantly
affect
bulb life and/or headlight
performance.
● High pressure halogen gas is sealed
inside the halogen bulb. The bulb may
break if the glass envelope is scratched
or the bulb is dropped.
● Use the same number and wattage as
shown in the chart.
1. Disconnect the negative battery cable.
2. Release the core support cover fasteners
᭺
A .
3. Access the rear of front headlight
᭺
B .
4. Position core support cover aside.
5. Rotate the (high beam) cover
᭺
C counter-
clockwise to access the (high beam) bulb
socket
᭺
E . Rotate the bulb socket
᭺
E coun-
terclockwise and remove bulb.
6. Rotate the (low beam) cover
᭺
D counter-
clockwise to access the (low beam) bulb
socket
᭺
F . Rotate the bulb socket
᭺
F coun-
terclockwise and remove bulb.
7. Rotate the side marker bulb socket
᭺
G coun-
terclockwise and remove bulb.
8. Rotate the turn signal bulb socket
᭺
H coun-
terclockwise and remove bulb
᭺
I .
Reverse instructions to install bulbs and replace
fender protector.
WARNING
Do not touch bulb by hand while it is lit or
right after being turned off. Burning may
result.
CAUTION
• Do not touch glass surface of the bulb
with bare hands or allow oil or grease to
get on it to prevent
damage to bulb.
• Do not leave the bulb out of the lamp
reflector for a long time because dust,
moisture, smoke, etc.
LDI2361
8-30 Maintenance and do-it-yourself