NISSAN 2015 Titan - Owner's Manual User Manual

Page 117

Advertising
background image

Key fob operation:

● Push the

button on the key fob.

All doors lock. The hazard lights flash
twice and the horn beeps once to indicate
all doors are locked.

● When the

button is pushed with

all doors locked, the hazard lights flash
twice and the horn beeps once as a re-
minder that the doors are already locked.

The horn may or may not beep. For addi-
tional information, refer to “Silencing the
horn beep feature” (vehicles without naviga-
tion system) in the “Pre-driving checks and
adjustments” section of this manual.

4. Confirm that the

indicator light comes

on. The

light stays on for about

30 seconds. The vehicle security system is
now pre-armed. After about 30 seconds the
vehicle security system automatically shifts
into the armed phase. The

light begins

to flash once every 3 seconds. If, during the
30-second pre-arm time period, the door is
unlocked by the key or the key fob, or the
ignition switch is placed to ACC or ON, the
system will not arm.

If the key is turned slowly when locking

the door, the system may not arm. Fur-
thermore, if the key is turned beyond
the vertical position toward the unlock
position to remove the key, the system
may be disarmed when the key is re-
moved. If the indicator light fails to
glow for a period of time, unlock the
door once and lock it again.

Even when the driver and/or passengers

are in the vehicle, the system will arm
with all doors closed and locked with the
ignition switch in the OFF position.

The lockable bedside storage compart-

ment (if so equipped) is not protected
by the vehicle security system.

Vehicle security system activation

The vehicle security system will give the following
alarm:

● The headlights blink and the horn sounds

intermittently.

● The alarm automatically turns off after a pe-

riod of time. However, the alarm reactivates if
the vehicle is tampered with again. The alarm
can be shut off by unlocking the driver’s door
with the key or by pressing the

button

on the key fob.

The alarm is activated by:

● Opening a door without using the key or key

fob (even if the door is unlocked by using the
inside lock knob or the power door lock
switch).

How to stop an activated alarm

The alarm stops only by unlocking the driver’s
door with the key or by pressing the

button

on the key fob.

NISSAN VEHICLE IMMOBILIZER
SYSTEM (if so equipped)

The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of a
registered key.

If the engine fails to start using a registered key
(for example, when interference is caused by
another registered key, an automated toll road
device or automatic payment device on the key
ring), restart the engine using the following pro-
cedures:

1. Leave the ignition switch in the ON position

for approximately 5 seconds.

2. Turn the ignition switch to the OFF or LOCK

position, and wait approximately 10 sec-
onds.

2-28

Instruments and controls

Advertising