NISSAN 2015 Titan - Owner's Manual - Manual (Page 378)

KEY FOB (if so equipped)
Replace the battery in the key fob as follows:
᭺
1 Open the lid using a coin
᭺
A .
᭺
2 Remove the battery
᭺
B .
᭺
3 Install a new battery
᭺
C with the “+” facing
down.
● Hold the battery by the edges. Holding the
battery across the contact points will seri-
ously deplete the storage capacity.
● Do not touch the internal circuit and electric
terminals as it could cause a malfunction.
● When changing the battery, do not let dust
or oil get on the key fob.
● There is danger of explosion if a lithium bat-
tery is incorrectly replaced. Replace only
with the same or equivalent type.
Recommended battery: CR2025 or equivalent.
᭺
4 Close the lid securely.
5. Press the button, then the
button two or three times to check the key
fob operation.
If the battery is removed for any reason
other than replacement, perform step 5.
● An improperly disposed battery can
hurt the environment. Always confirm
local regulations for battery disposal.
● The key fob is water-resistant; how-
ever, if it does get wet, immediately
wipe completely dry.
● The operational range of the key fob
extends to approximately 33 ft (10 m)
from the vehicle. This range may vary
with conditions.
LDI2026
Maintenance and do-it-yourself 8-27