Sealing a tire with tirefit – Dodge 2011 Challenger - Owner Manual User Manual

Page 357

Advertising
background image

WARNING! (Continued)

TIREFIT Sealant solution contains latex. In case of

an allergic reaction or rash, consult a physician
immediately. Keep TIREFIT out of reach of chil-
dren. If swallowed, rinse mouth immediately with
plenty of water and drink plenty of water. Do not
induce

vomiting!

Consult

a

physician

immediately.

Sealing A Tire With TIREFIT

(A) Whenever You Stop To Use TIREFIT:

1. Pull over to a safe location and turn on the vehicle’s

Hazard Warning flashers.
2. Verify that the valve stem (on the wheel with the

deflated tire) is in a position that is near to the ground.

This will allow the TIREFIT Hoses (6) and (7) to reach the

valve stem and keep the TIREFIT kit flat on the ground.

This will provide the best positioning of the kit when

injecting the sealant into the deflated tire and running the

air pump. Move the vehicle as necessary to place the

valve stem in this position before proceeding.
3. Place the transmission in PARK (auto transmission) or

in Gear (manual transmission) and turn Off the ignition.
4. Set the parking brake.
(B) Setting Up To Use TIREFIT:

1. Turn the Mode Select Knob (5) to the Sealant Mode

position.
2. Uncoil the Sealant Hose (6) and then remove the cap

from the fitting at the end of the hose.
3. Place the TIREFIT kit flat on the ground next to the

deflated tire.

6

WHAT TO DO IN EMERGENCIES 355

Advertising