Jacking and tire changing – Dodge 2011 Challenger - Owner Manual User Manual

Page 362

Advertising
background image

2. Locate the round Sealant Bottle release button in the

recessed area under the sealant bottle.
3. Press the Sealant Bottle release button. The Sealant

Bottle (1) will pop up. Remove the bottle and dispose of

it accordingly.
4. Clean any remaining sealant from the TIREFIT hous-

ing.
5. Position the new Sealant Bottle (1) in the housing so

that the Sealant Hose (6) aligns with the hose slot in the

front of the housing. Press the bottle into the housing. An

audible click will be heard indicating the bottle is locked

into place.
6. Verify that the cap is installed on the fitting at the end

of the Sealant Hose (6) and return the hose to its storage

area (located on the bottom of the air pump).
7. Return the TIREFIT kit to its storage location in the

vehicle.

JACKING AND TIRE CHANGING

WARNING!

Do not attempt to change a tire on the side of the

vehicle close to moving traffic. Pull far enough off
the road to avoid the danger of being hit when
operating the jack or changing the wheel.

Being under a jacked-up vehicle is dangerous. The

vehicle could slip off the jack and fall on you. You
could be crushed. Never put any part of your body
under a vehicle that is on a jack.

Never start or run the engine while the vehicle is

on a jack. If you need to get under a raised vehicle,
take it to a service center where it can be raised on
a lift.

(Continued)

360 WHAT TO DO IN EMERGENCIES

Advertising