Ram Trucks MEDIA CENTER 430N for Jeep - Manual (Page 11)

NOTE: If you are viewing the NAV screen (Media
Center 430N only), pressing the RADIO hard-key will
return you to the RADIO mode screen.
(4) MEDIA
Press the MEDIA hard-key (4) to change to a MEDIA
mode or to toggle between MEDIA modes; HDD (Hard
Disk Drive), CD/DVD or AUX.
NOTE: If you are viewing the NAV screen (Media
Center 430N only), pressing the MEDIA hard-key will
return you to the MEDIA mode screen.
(5) ON/OFF VOLUME
It is also possible to set the unit in standby mode during
driving by pressing the ON/OFF VOLUME rotary knob
(5).
NOTE: If the ignition is switched OFF with the radio in
standby mode, the radio memorizes the standby state
when the ignition is switched ON again. Press the (5)
ON/OFF VOLUME rotary knob to switch the radio ON.
The radio software is always working when the ignition
is switched ON, even if the radio is in standby mode. It is
still possible to eject the CD and to display the time if the
unit is switched OFF.
(6) LOAD
To open or close the display, press the LOAD hard key
(6).
After opening the display, it takes a few seconds to eject
a CD/DVD, if one was in the slot.
When inserting a disc, make sure the label is facing up.
The display will close automatically after inserting the
disc.
NOTE: It may take several seconds to recognize the type
of inserted disc (CD, DVD, MP3, etc.).
10 MEDIA CENTER 430/430N (RBZ/RHB)