Cooling system, Coolant checks – Dodge 2015 Challenger - Owner Manual User Manual

Page 528

Advertising
background image

Cooling System

WARNING!

When working near the radiator cooling fan,

disconnect the fan motor lead or place the ignition
in the LOCK position (OFF position for Keyless
Enter-N-Go™). The fan is temperature controlled
and can start at any time the ignition switch is in
the ON position (RUN position for Keyless Enter-
N-Go™).

You or others can be badly burned by hot engine

coolant (antifreeze) or steam from your radiator. If
you see or hear steam coming from under the hood,
do not open the hood until the radiator has had
time to cool. Never try to open a cooling system
pressure cap when the radiator is hot.

Coolant Checks
Check engine coolant (antifreeze) protection every 12

months (before the onset of freezing weather, where

applicable). If coolant is dirty or rusty in appearance, the

system should be drained, flushed, and refilled with

fresh coolant. Check the front of the radiator for any

accumulation of bugs, leaves, etc. If dirty, clean by gently

spraying water from a garden hose vertically down the

face of the condenser.
Check the coolant recovery bottle tubing for brittle rub-

ber, cracking, tears, cuts, and tightness of the connection

at the bottle and radiator. Inspect the entire system for

leaks.
With the engine at normal operating temperature (but

not running), check the cooling system pressure cap for

proper vacuum sealing by draining a small amount of

coolant from the radiator drain cock. If the cap is sealing

properly, the engine coolant (antifreeze) will begin to

526 MAINTAINING YOUR VEHICLE

Advertising