Cisco 8800 - Manual (Page 16)

xlviii
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Documentation
Cisco MGX 8850 Edge Concentrator Installation and
Configuration, Release 1.1.3
DOC-7811223=
Provides installation instructions for the Cisco MGX 8850
(PXM1) edge concentrator.
Cisco MGX 8850 Multiservice Switch Overview, Release 1.1.3
OL-1154-01
Describes the system components and function of the
Cisco MGX 8850 (PXM1) edge concentrator.
Cisco MGX and Service Expansion Shelf Error Messages,
Release 5.0
OL-6485-01
Provides error message descriptions and recovery
procedures.
Cisco MGX Route Processor Module (RPM-XF) Installation
and Configuration Guide, Release 5.2
OL-6954-01
Describes how to install and configure the Cisco MGX Route
Processor Module (RPM-XF) in the Cisco MGX 8850
(PXM45), Cisco MGX 8880 (PXM45), and Cisco MGX 8950
switch. Also provides site preparation procedures,
troubleshooting procedures, maintenance procedures, cable
and connector specifications, and basic Cisco IOS
configuration information.
Cisco MGX Route Processor Module (RPM-PR) Installation
and Configuration Guide, Release 5.2
OL-7349-01
Describes how to install and configure the Cisco MGX Route
Processor Module (RPM/B or RPM-PR) in the
Cisco MGX 8850 (PXM1), the Cisco MGX 8250, and the
Cisco MGX 8230 edge concentrators. Also provides site
preparation procedures, troubleshooting procedures,
maintenance procedures, cable and connector specifications,
and basic Cisco IOS configuration information.
Cisco PNNI Network Planning Guide for MGX and SES
Products
OL-3847-01
Provides guidelines for planning a PNNI network that uses
Cisco MGX 8830, Cisco MGX 8850 (PXM45 and PXM1E),
Cisco MGX 8950, or Cisco BPX 8600 switches or the
MGX 8880 Media Gateway. When connected to a PNNI
network, each Cisco BPX 8600 Series switch requires an SES
for PNNI route processing.
Cisco Service Expansion Shelf Hardware Installation Guide,
Release 1
DOC-786122=
Provides instructions for installing and maintaining an SES
controller.
Cisco SES PNNI Controller Command Reference, Release 3
DOC-7814260=
Describes the commands used to configure and operate the
SES PNNI controller.
Cisco SES PNNI Controller Software Configuration Guide,
Release 3
DOC-7814258=
Describes how to configure, operate, and maintain the SES
PNNI controller.
Cisco Voice Interworking Services (VISM) Configuration
Guide and Command Reference, Release 3.3
OL-5358-01
Describes how to install and configure the Voice
Interworking Service Module (VISM) in the Cisco
MGX 8830, Cisco MGX 8850 (PXM45), and Cisco MGX
8850 (PXM1E) multiservice switches. Provides site
preparation procedures, troubleshooting procedures,
maintenance procedures, cable and connector specifications,
and Cisco CLI configuration information.
Table 5 User Guides and Release Notes for Cisco Multiservice Switch Products (continued)
Document Title Description