Canon EOS 10D - Manual (Page 169)

169
Ref
erence
13
On-screen Messages
Cannot print! The image was captured by another camera or in an incompatible
format. Or the image has been edited with a personal computer.
Description Message
Could not print **
images The image was captured by another camera or it has been edited with
a personal computer and printing was attempted in accordance with
the DPOF setting for ** prints.
** images remaining Since the printing with the DPOF setting was interrupted, ** prints still
remain to be printed.
Cannot trim The image was captured by another camera or it is in an incompatible
format. Or the image has been edited with a personal computer. Such
images cannot be trimmed.
When a BJ printer capable of direct printing is connected to the camera, the camera’s LCD
monitor may display any of the messages below. If any of these messages are displayed,
check the error code on the BJ printer’s operation panel and refer to the BJ printer’s manual for
the error description.
No paper The paper has not been inserted properly or there is no paper. Or
there is a problem with the paper feed operation.
Description Message
No ink There is no ink tank or the ink tank has no ink.
Paper jam The paper jammed during printing.
Printer in use Printing from the personal computer or the memory card in the printer
is in progress. When the printing ends, the images in the camera’s CF
card will start printing automatically.
Printer warming up The printer is preparing for printing. When the printer is ready, printing
will start automatically.
No printhead There is no print head.
Printer cover open Close the printer’s front cover.
Media type error Paper that the printer cannot use has been selected. Select a paper
that can be used with the [Style] setting on the camera’s direct
printing screen.
Paper lever error Set the paper spacing lever to the proper position.
Low ink level The ink tank must be replaced soon. Keep a new ink tank on hand. To
resume printing, select [Resume] on the error message screen.
Battery level is too
low. Direct printing was not possible, because the camera battery level is
too low.