Baumer BA OADM20I6 OADM21I6 User Manual
Page 34
Advertising
BA_OADM20I6_21I6_most.doc
34/88
Baumer
26.03.13
Frauenfeld, Switzerland
Steps / edges:
When measuring right next to steps / edges, it is important that the receiving beam is not covered by the
steps / edges. This also applies to depth measurements of holes or valleys.
Mounting above shiny surfaces:
On shiny surfaces, it is important that no direct reflection can get to the receiving optics. The reflection could
blind the sensor and produce poor results. To prevent this, the sensor may be slightly tilted. The direct
reflection can be seen on a white piece of paper when held in front of the receiver.
Mounting above round, shiny surfaces:
☺
☺
☺
☺
☺
☺
☺
☺
☺
☺
☺
☺
10 -15°
☺
☺
☺
☺
Advertising