CDA DV 990 - Manual (Page 32)

32
Telescopic Sliding Shelf Supports
The telescopic sliding shelf supports make it safer and easier to insert and
remove the oven shelves and trays. They stop when they are pulled out to the
maximum position.
Important! When fitting the sliding shelf supports, make sure that you fit:
– The slides to the top wire of a rack. They do not fit on the lower wire.
– The slides so that they run out towards the oven door.
– Both sides of each pair of shelf slides.
– Both sides on the same level.
– In the top oven, you can only fit the slides on the wire immediately below the side rack fixing screws.
To fix the sliding shelf support onto the side racks:
– Screw the side rack onto the oven wall (Figs. 16a-16b).
– Fit the sliding shelf support onto the top wire of a rack and press (Figs. 16a-16b). You will hear a click as
the safety locks clip over the wire.
Left
Right
Fig. 16b
Models:
9Q6..
9Z6..
Left
Right
Fig. 16a