FRIGIDAIRE FPHG2399PF - Manual (Page 12)

12
Door Handle Mounting Instructions for Frigidaire Professional®
1 Remove handles from carton and any other protective packaging.
2 Position fresh food handle end over upper and lower pre-installed shoulder bolts (A) that are fastened into door,
ensuring the holes for the set screws are facing towards the opposite door.
3 While holding handle firmly against door, fasten upper and lower Allen set screws (B) with supplied Allen wrench.
4 Repeat steps 2 and 3 to install opposite handle. Ensure the holes for the set screws are facing towards the first door.
5 Position freezer handle end over left and right pre-installed handle mounts that are fastened to the door, ensuring
the holes for the set screws are facing down.
6 While holding handle firmly against door, loosely tighten far right Allen set screw (B) with supplied Allen wrench until there is
no gap between handle and door.
7 Still holding the handle firmly to the door, firmly tighten far left Allen set screw (B) with supplied Allen wrench.
8 Return to the far right Allen set screw (B) and firmly tighten with supplied Allen wrench.
9 Firmly tighten the inside Allen set screws.
INSTALLING DOOR HANDLES
 NOTE
All set screws should be tightened so the screw is below the surface of the handle. The handles should be drawn
tight to freezer and refrigerator doors with no gaps. Opening the opposite door while tightening the Allen screw
makes installation easier.
The door handle may loosen over time or if it was installed improperly. If this happens, tighten the set screws on
the handles.
Mounting Refrigerator Handles
Mounting Freezer Handle
CAUTION
Wear gloves and safety goggles. Use extreme CAUTION
when installing these handles.