Changing the filter interior lighting, Pure advantage™ air filter, Important – FRIGIDAIRE FGRU19F6QF User Manual

Page 13

Advertising
background image

13

Mid-Level Lighting Light Bulb Removal

To Remove Light Lens

Press Tabs

in Direction Shown

Mid Level Lighting

PURE ADVANTAGE™ Air Filter

Your new Pure Advantage air filter is located inside

one of the 2-Liter Door Bins. The air filter cover is

located on the upper right side of the control box.

In general, you should change the air filter with

Part Number “EAFCBF” every 6 months to ensure

optimal filtering of freezer odors. The replacement

air filter can be purchased on the Frigidaire website

(http://frigidaire.stores.yahoo.net) or call toll free

in the U.S. and Canada: 1-800-599-7569. Your

electronic control is equipped with a Replace Air

Filter indicator to remind you to change your filter.
To Install Or Replace The Air Filter

• Pull down on the front of the Pure

Advantage™ air filter cover to release the

hinged bottom cover.

• Allow bottom cover to swing open and then

remove the old filter and discard it.

• Unpackage the new filter and place it inside

the hinged bottom cover of the housing.

• Push the hinged bottom cover upward until

the tab snaps into closed position.

replace air filter

hold to reset

press & hold

air

filter

temp

mode

alarm

off

control

lock

Open Air Filter Cover

Air Filter

Remove Air Filter

The mid level and upper level lighting comes on

automatically when the door is opened.

IMPORTANT

To disconnect power to the unit, unplug the

unit or switch the breaker that supplies power

to the unit to the off position. Replace the old

bulb with a bulb of the same wattage.

To replace the light bulbs:

1. To replace the light bulb, turn the

temperature control to OFF and unplug the

electrical cord.

2. Remove the lens from the lamp housing by

unsnapping it from the lamp housing using

your fingers or a screwdriver. Be careful not to

break the locking tabs on the lamp housing.

3. Replace the old bulb with a bulb of the same

type and wattage.

4. To replace the lens, snap one side of the

lens opening to the tab on the lamp housing.

Then carefully attach the other side.

CHANGING THE FILTER

INTERIOR LIGHTING

Advertising
This manual is related to the following products: