FRIGIDAIRE FGRU19F6QF - Manual (Page 6)

6
To Level the Refrigerator:
While unit is lying on its back, note the location
of the four (4) leg levelers installed at each
corner. These leg levelers will be used to level
the refrigerator and to adjust the height. Use a
carpenter’s level to level the refrigerator from
front to back and side to side. Adjust the plastic
leveling feet in front, ½ bubble higher, so that
the door closes easily when left halfway open.
INSTALLATION
 NOTE
All set screws should be tightened and sub-
flush (Allen set screw should be seated just
below the surface of the end cap) of handle
end cap. The end caps should be drawn tight
to refrigerator door with no gaps.
Kick Plate Removal
To remove the kick plate, use a Phillips head
screwdriver and remove the two screws holding
the kick plate to the cabinet. Then pull the kick
plate away from the unit.
Leveling
The refrigerator must have all bottom corners
resting firmly on a solid floor.
The floor must be strong enough to support a
fully loaded refrigerator.
It is VERY IMPORTANT for your refrigerator to be
level in order to function properly. If the refrigerator
is not leveled during installation, the door may be
misaligned and not close or seal properly, causing
cooling, frost or moisture problems.
Leveling Instructions for Matching
Refrigerator / Freezer Pair:
• Level door of first unit using all four levelers
and slide unit into place. Recheck for
levelness and adjust if necessary.
• Measure distance from floor to bottom of
door on first unit. Adjust and level second
unit so door height matches.
Leg Level Adjustments:
• One full turn of all four leg levelers will raise
door 5/32”.
• Slide second unit into place leaving a
minimum gap of 3/16” between units for
door swing clearance.
• This last step may require at least one
extraction of the second unit to properly
align units in a “built-in” application.
Leveling Door with Adjustable Hinge
Use the lower hinge adjustment to fine tune the
door height and for final cabinet spacing. Use a
7/16” socket or wrench to adjust the screw at the
bottom of the lower hinge.
Adjusting Doors for Matching Refrigerator /
Freezer Pair
The doors may also be adjusted side to side with
the slotted hinge for aligning the doors parallel
to each other. Loosen the two bolts with a
⅜
”
A
B
Single Unit Installation
Matching Refrigerator and Freezer Door
Handle Installation
Kick Plate Removal