Four-post rack installation, Rack stabilizer feet, Recommended tools and supplies – Dell PowerEdge SC1425 User Manual
Page 9: Rapidrails rack kit contents, Figure 1-1
Rack Installation Guide
1-7
Four-Post Rack Installation
Before attempting this installation, read through this entire procedure carefully.
Rack Stabilizer Feet
CAUTION:
Installing systems in a rack without the front and side stabilizer feet installed and anchored
to the floor could cause the rack to tip over, potentially resulting in bodily injury under certain
circumstances. Therefore, always install and anchor the stabilizer feet before installing components
in the rack.
The stabilizer feet help prevent the rack from tipping over. See the documentation provided
with the rack cabinet for instructions on installing and anchoring the stabilizer feet.
Recommended Tools and Supplies
You may need the following items to install the system in a four-post rack cabinet:
•
#2 Phillips screwdriver
•
Masking tape or a felt-tip pen, for use in marking the mounting holes to be used
RapidRails Rack Kit Contents
•
One pair of RapidRails mounting rails
•
Releasable tie wraps (2) (not shown in Figure 1-1)
Figure 1-1.
RapidRails Rack Kit Contents
mounting rails (2)
releasable tie wrap attachment points (2)