Dell PowerEdge 1750 User Manual
Page 6
1-2
I n s t a l l i n g o r Re p l a c i n g a n E RA / O C a r d
www
.dell.com | support.dell.com
F i g u r e 1 - 1 .
O p e n i n g t h e S y s t e m C o v e r s
6
Remove the SCSI backplane board:
a
Pull each hard-drive carrier partially out of its slot, approximately 2.5 cm (1 inch).
b
Disconnect the diskette-drive interface cable from the FLOPPY connector on the
backplane board. See Figure 1-2.
c
Disconnect the CD drive interface cable from the CD_ROM connector on the
backplane board. See Figure 1-2.
d
Press the release latch in toward the backplane board and use the handle to pull
the board out of its connector and up out of the chassis. See Figure 1-2.
latch
optional security screw
right cover
left cover
K0238ebk0.book Page 2 Monday, February 24, 2003 2:53 PM