Dell PowerEdge 1750 - Manual (Page 7)

I n s t a l l i n g o r Re p l a c i n g a n E RA / O C a r d 1-3
F i g u r e 1 - 2 . S C S I B a c k p l a n e B o a r d
7 If the system has an optional ROMB card installed, remove the ROMB backup battery
(not the ROMB card itself) to expose the ERA/O card connector.
See Figure 1-3; see also "Removing a ROMB Card" in your Installation and
Troubleshooting Guide.
8 Unpack the ERA/O card.
If you are replacing an ERA/O card, see "Removing an ERA/O Card" for removal
instructions before continuing with the next step.
CD drive interface
connector (CD_ROM)
diskette drive interface connector
(FLOPPY)
handle
release latch
tabs (2)
K0238ebk0.book Page 3 Monday, February 24, 2003 2:53 PM