Dell PowerEdge 1750 User Manual
Page 8
1-4
I n s t a l l i n g o r Re p l a c i n g a n E RA / O C a r d
www
.dell.com | support.dell.com
F i g u r e 1 - 3 .
R e m o v i n g t h e R O M B B a c k u p B a t t e r y
9
Install the ERA/O card in the ERA/O card connector (EMBEDDED_REMOTE_
ASSISTANT) on the system board. See Figure 1-4.
a
Align the connector on the bottom of the ERA/O card with the ERA/O connector
on the system board; align the holes along the edges of the card with the center
posts of the four retention clips on the system board.
b
Press the card down into the connector and onto the retention clip posts until the
clips snap into place around the card and the card is fully seated into the
connector.
ROMB backup
battery
RAID BATTERY connector
battery standoffs (2)
ROMB card
ERA/O card
connector
K0238ebk0.book Page 4 Monday, February 24, 2003 2:53 PM