Cobra Electronics ESD-9220 WX - Manual (Page 12)

Detection
16
Tone Alarm
And Voice
Alert™
Detection
17
Radar
The display will show the band (X, K/Ka). The
signal strength will first be indicated by the band
being illuminated, then by signal strength
LEDs which increase in size as you approach the
radar gun. At the same time the frequency of the
beeps will increase. Distinct tones will also be
generated for each band.
Radar
Voice Alert™
Auxiliary Audio Jack
Use to connect an external speaker to your Cobra®
ESD-9220 WX in environments with high ambient
noise levels.The internal speaker will be disconnected.
The audio output will be voice or tone depending on
your selection.
Auxiliary
Audio Jack
Band Detection
This detector is designed to detect X, K,
Superwide Ka Band Radar, Laser (including LTI
20-20*, Ultra Lyte* and ProLaser* technologies),
VG-2, Safety Alert® and Strobe Alert™* signals.
*360˚ Detection
Band
Detection
Audible Alarm Speaker
A different alert tone will sound for X, K, Ka, Laser
(plus a distinctly different tone for each of the three
laser signals: LTI 20-20, Ultra Lyte and ProLaser),
VG-2, and Safety/Strobe Alert™ signals. Audible Alarm
Speaker
Bands Signal Strength
Instant-On Detection
The Cobra® ESD-9220 WX is also designed to
detect Instant-on speed monitoring signals.
Immediate action is required when warning
is given.
Voice Alert™
The ESD-9220 WX will also announce the reception
of these signals with the statement,”Be careful...X
Alert, K Alert, Ka Alert, Laser Alert, VG-2 Alert®,
Emergency Vehicle Approaching, Road Hazard
Ahead, Train Approaching, Weather Alert.”
Voice/Tone Settings
PRESS &
RELEASE
City/ Wx
Press and hold MUTE button for two seconds
to change between Voice and Tone Alarms.
1
Note
The factory default setting
is Voice Alert™ Mode.