Cabletron Systems HSIM-F6 - Manual (Page 49)

The Full Duplex Configuration Screen
HSIM-F6 User’s Guide 3-25
3.9.2 Full Duplex Configuration Screen Fields
The following list describes each of the Full Duplex Configuration screen
fields:
Operation Mode
This is a read-only field that displays the current operating parameters of
the port. This field reads “Standard FDDI” or “Full Duplex”.
Link Status
This is a read-only field that will display “Link” or “No Link”.
Port Status
This is a read-only field that will display “Enabled” or “Disabled”.
SET OPERATION MODE
This field toggles between [STANDARD FDDI] and [FULL DUPLEX].
To change the current selection, use the arrow keys to highlight the field
and press the SPACE bar.
DESIRED OPERATION MODE
This read-only field displays the desired operation mode of the HSIM-F6.
In some cases, the HSIM-F6 will not begin operating in full duplex mode
immediately. This field confirms that changes to the SET OPERATION
MODE field have been saved, and the HSIM-F6 is in the process of
changing to the operation mode that is displayed in this field.
SAVE
This command saves all configuration changes to memory.