Dell PowerVault 220S (SCSI) - Manual (Page 14)

1-10 Rack Installation Guide
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m 5 Using two 10-32 x 0.5 Phillips screws, secure the back mounting-bracket flange to the
back vertical rail.
6 Repeat steps 1 through 5 for the remaining mounting rail on the other side of the rack.
7 Ensure that the mounting rails are mounted at the same position on the vertical rails
on each side of the rack.
Installing the Tower-to-Rack Conversion Kit
NOTE: If you have a rack-only version of the system, skip this procedure and proceed to
“Installing the System in the Rack.”
CAUTION: Your system may be very large and heavy. To prevent personal injury,
do not attempt to move the system by yourself.
The tower-to-rack conversion kit includes a rack front panel with rack handles and
thumbscrews.
Removing the Bezel, Drives, Covers, and Front Panel
1 Shut down and turn off power to your system and disconnect your power and
peripheral cables.
2 To remove the bezel (see Figure 1-7):
a Using the system key, unlock the front bezel.
b Swing the bezel away and down from the system until it is perpendicular to the
system.
c Loosen the two thumbscrews that secure the bezel hinge to the front panel (see
Figure 1-7).
d Pull the bezel away and set it aside.