Dell OptiPlex 330 (Late 2007) - Manual (Page 33)

Quick Reference Guide
33
Removing the Computer Cover
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
1 Follow the procedures in "Before You Begin" on page 10.
NOTE:
Ensure that sufficient space exists to support the removed cover.
NOTICE:
Ensure that you are working on a level, protected surface to avoid
scratching either the computer or the surface on which it is resting.
2 If you have installed a padlock through the padlock ring on the back panel,
remove the padlock.
3 Slide the cover release latch back as you lift the cover.
8 VGA video
connector Connect the monitor’s VGA cable to the VGA connector on
the computer.
On computers with a video card, use the connector on the
card.
9 serial connector Connect a serial device, such as a handheld device, to the
serial port. The default designation is COM1 for serial
connector 1.
For more information, see "System Setup Options" in the
online User’s Guide.