Dell OptiPlex 330 (Late 2007) - Manual (Page 55)

Quick Reference Guide
55
C M O S CHECKSUM ERROR — Possible motherboard failure or RTC battery low.
Replace battery.
C P U FAN FAILURE — CPU fan failure. Replace the CPU fan.
D ISKETTE DRIVE 0 SEEK FAILURE — A cable may be loose, or the computer
configuration information may not match the hardware configuration. Check cable
connections.
D ISKETTE READ FAILURE — The floppy disk may be defective or a cable may be
loose. Replace the floppy disk/check for a loose cable connection.
H ARD - DISK DRIVE FAILURE — Possible hard disk drive failure during HDD
POST. Check cables /swap hard disks.
H ARD - DISK DRIVE READ FAILURE — Possible HDD failure during HDD boot test.
K EYBOARD FAILURE — Keyboard failure or keyboard cable loose.
N O BOOT DEVICE AVAILABLE — The system cannot detect a bootable device or
partition.
• If the floppy drive is your boot device, ensure that the cables are connected and
that a bootable floppy disk is in the drive.
• If the hard drive is your boot device, ensure that the cables are connected and
that the drive is installed properly and partitioned as a boot device.
• Enter system setup and ensure that the boot sequence information is correct.
N O TIMER TICK INTERRUPT — A chip on the system board might be
malfunctioning or motherboard failure.
N ON - SYSTEM DISK OR DISK ERROR — Replace the floppy disk with one that has
a bootable operating system or remove the floppy disk from drive A and restart the
computer.