Vermont Casting DVT38S2IN - Manual (Page 30)

30
Chateau™ Direct Vent Gas Fireplace
20011957
1. Ensure the four (4) screws that attach the
fettle to the burner are secure.
2. Set the andirons in place by hooking the tabs
on the back of the andirons over the webs of
the fettle. (Fig. 43) Repeat process for and-
irons on both sides of burner.
������
������������
����
Andirons
Burner
Housing
Burner Tubes
Fettle
FP1803
Figure 43
3. Place the volcanic rock in front of
each burner tube assembly and
around the burner assembly as
desired. (Fig. 44) Do not obstruct
fresh air inlet with volcanic rock.
4. Place the ember material lightly,
between each burner tube as-
sembly and the burner housing,
between the joined burner tubes
and in front over the burner tube
and on top of burner tube.
NOTE: The ember material must
be built up from the burner tubes
to the burner housing fronts in
order for the burner tubes to light
properly.
�����
�������������������
����
Figure 44
LG486
Ember Material
Lava Rock
5. Position the log pilot plumb-
ing. (Fig. 45) Hold the log with
the two (2) branches facing
down and set it down over
the pilot plumbing with the flat
side of the log touching the
side refractory.
�����
���������
����
Log Pilot Plumbing (F50)
LG493
Figure 45