Installing the input/output panel, Removing the power supply – Dell OptiPlex 3010 (Mid 2012) User Manual
Page 26
Installing the Input/Output Panel
1.
Insert the Input/Output panel into the slot on the chassis front.
2.
Slide the Input/Output panel towards the right of the computer to secure to the chassis.
3.
Tighten the single screw to secure the Input/Output panel to the chassis.
4.
Thread the Input/Output panel or the FlyWire cable into the chassis clip.
5.
Connect the Input/Output panel or the FlyWire cable to the system board.
6.
.
7.
.
8.
After Working Inside Your Computer
.
Related Links
Removing the Input/Output Panel
Removing The Power Supply
1.
Before Working Inside Your Computer
2.
Remove the
.
3.
Disconnect the power cables connected to the hard drive(s) and optical drive(s).
4.
Unthread the power cables from the clips in the computer.
5.
Disconnect the 24-pin power cable from the system board.
26