Adding or removing an expansion card, Installing an expansion card – Dell PowerVault 725N (Rackmount NAS Appliance) User Manual
Page 35
2.
Push the release lever to the right. See
3.
Open the latch and use it to pull the drive carrier out of the drive bay.
4.
Remove the screws on the bottom of the carrier and remove the drive from the carrier. See
.
Figure 5-2. Releasing the Hard-Drive Latch
Figure 5-3. Removing the Hard Drive From the Drive Carrier
5.
Disconnect the drive carrier's power and IDE cables from the drive.
6.
Connect the power and IDE cables to the new drive.
7.
Place the drive back in the carrier and reattach the screws that you removed in step 4.
8.
Insert the carrier, with the latch open, into the system.
9.
Push the carrier into the drive bay until it is fully seated in the backplane connector.
10.
Close the latch.
11.
Replace the front panel.
If it is necessary to reinstall your system, see your System Administrator's Guide.
Adding or Removing an Expansion Card
The system supports up to two PCI expansion cards, which are installed in connectors on a riser board at the back of the system.
Installing an Expansion Card
NOTE:
Do not remove rubber grommets.