Dell PowerVault 200S (SCSI) - Manual (Page 7)

Dell PowerVault 2xxS Storage Systems SCSI Backplane Board Replacement Instructions 7
1. Using a Phillips-head screwdriver, loosen the captive screw at the top of
the enclosure services module.
2. Grasp the handle on the enclosure services module and pull it from the
module bay (see Figure 7).
Figure 7. Enclosure Services Module Removal
3. Repeat steps 1 and 2 to remove the remaining enclosure services module.
Remove the Component Mounting Bracket
To remove the component mounting bracket, perform the following steps:
1. Using a Phillips-head screwdriver, remove the two screws that secure the
component mounting bracket to the chassis (see Figure 8).
2. Lift the component mounting bracket slightly and slide it out of the chassis.
captive screw