Dell PowerEdge VRTX - Manual (Page 12)

Click Chassis Overview → Update and see if the CMC firmware needs to be updated.
1. Log in to the CMC GUI by using the management station.
2. In Chassis Overview, click the Update tab in the right pane.
The Firmware Update page is displayed.
Figure 2. Updating the CMC Firmware
3. Select the check box under CMC Firmware and click Apply CMC Update.
NOTE: If you have two CMC applications, select both.
4. Click Browse and select the CMC firmware update you downloaded by following the steps in
Downloading Firmware and Drivers .
5. Click Begin Firmware Update.
During this process, the CMC software goes offline for some time.
Check the CMC firmware version again to see if the update was successful.
Updating the PowerEdge VRTX Chassis Infrastructure
Firmware
Click Chassis Overview → Update and see if the PowerEdge VRTX chassis infrastructure firmware needs
updating.
1. Log in to the CMC GUI by using the management station.
2. Confirm that the PowerEdge VRTX chassis is turned on in Chassis Overview → Power.
3. Confirm that the server modules are turned off in Server Overview → Power
4. Navigate to Chassis Overview, click the Update tab.
The Firmware Update page is displayed.
5. Under Chassis Infrastructure Firmware, click Apply.
6. Click Browse and select the chassis infrastructure firmware update you downloaded by following the
steps in Downloading Firmware and Drivers .
7. Click Begin Firmware Update.
After the firmware update is complete, the PowerEdge VRTX system power cycles to initialize the
updated firmware. The process takes up to 25 minutes.
8. Click Chassis Overview → Update Page to confirm that the firmware is updated.
12