Dell Inspiron 20 (3045, Early 2014) - Manual (Page 69)

Replacing the Camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer . After working inside your
computer, follow the instructions in After Working Inside Your
Computer . For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Slide the camera into the camera bracket and align the screw hole on the
camera with the screw hole on the camera bracket.
2 Replace the screw that secures the camera to the camera bracket.
3 Connect the camera cable to the camera.
4 Align the screw holes on the camera assembly with the screw holes on
the display bezel.
5 Replace the screws that secure the camera assembly to the display bezel.
6 Align the screw holes on the display-panel base with the screw holes on
the display bezel and snap the display-panel base into place.
7 Replace the screws that secure the display-panel base to the display
bezel.
8 Connect the converter-board cable to the connector on the display
panel.
9 Connect the control-buttons board cable to the control-buttons board.
10 Route the speaker cable through the routing guides on the display-panel
base and connect the speaker cable to the system board.
11 Route the camera cable through the routing guides on the display-panel
base and connect the camera cable to the system board.
12 Slide the display cable into the connector on the system board and press
down on the connector latch to secure the cable.
Postrequisites
1 Replace the system-board shield .
2 Replace the back cover .
3 Replace the stand assembly .
69