Dell Inspiron 20 (3045, Early 2014) - Manual (Page 76)

Replacing the Display Panel
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer . After working inside your
computer, follow the instructions in After Working Inside Your
Computer . For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the display-panel brackets with the screw holes
on the display panel.
2 Replace the screws that secure the display-panel brackets to the display
panel.
3 Align the screw holes on the display panel with the screw holes on the
display bezel and place the display panel on the display bezel.
NOTE: Make sure that no cables are under the display panel.
4 Connect the display cable to the connector on the display panel and
secure the cable with the tape.
5 Align the screw holes on the display-panel base with the screw holes on
the display bezel and snap the display-panel base into place.
6 Replace the screws that secure the display-panel base to the display
bezel.
7 Connect the converter-board cable to the connector on the display
panel.
8 Connect the control-buttons board cable to the control-buttons board.
9 Route the speaker cable through the routing guides on the display-panel
base and connect the speaker cable to the system board.
10 Route the camera cable through the routing guides and connect the
camera cable to the system board.
11 Slide the display cable into the system-board connector and press down
on the connector latch to secure the cable.
Postrequisites
1 Replace the speaker cover .
2 Replace the system-board shield .
76