Dell PowerVault NX1950 - Manual (Page 34)

34
Setting Up MSCS
9 In the Cluster Configuration Quorum window, specify the iSCSI disk
associated with the PS Series volume you configured for the quorum
resource and click OK. When the Proposed Cluster Configuration
window appears again, click Next.
10 The PowerVault NX1950 cluster system is created on the node you
specified in Step 4. If the Cluster Wizard finds any errors, a condition is
flagged. You can expand the failed object to obtain the details required to
correct the issue. Click Next to continue if you do not have any critical
errors that prevent the cluster from completing the configuration.
NOTE:
If you are using DHCP, you may receive a warning, as shown in the figure
below, that one or more network adapters are configured to use DHCP. Although the
cluster performs with a network adapter set to use DHCP, it is not recommended.
11 After the cluster configuration is complete, the Cluster Wizard enables
you to view the log. Click Finish to exit the wizard.
Modifying the Cluster Network Configuration
After the cluster installation is complete, the Cluster Administrator displays
all the objects that were automatically created. You must make configuration
changes that are specific to your cluster environment to the network object.
To modify the cluster network configuration:
1 In the left panel, expand Cluster Configuration and click Networks. The
network adapters active on the node appears in the right panel as shown in
Figure 6-1.
Figure 6-1. Cluster Administrator - Networks
Book.book Page 34 Monday, February 4, 2008 1:26 PM