Unidentified devices, Recovering from an unidentified storage array – Dell PowerVault MD3000 User Manual
Page 104
104
Troubleshooting
Unidentified Devices
An unidentified node or device occurs when the MD Storage Manager cannot
access a new storage array. Causes for this error include network connection
problems, the storage array is turned off, or the storage array does not exist.
NOTE:
Before beginning any recovery procedure, make sure that the host-agent
software is installed and running. If you started the host before the host was
connected to the storage array, the host-agent software will not be able to find the
storage array. If so, make sure that the connections are tight, and restart the host-
agent software.
•
If a storage array is managed by using both out-of-band management and
in-band management using the same host, a management network
connection problem might prevent direct communication with the storage
array. However, you might still be able to manage the storage array over the
in-band connections. The opposite situation can also occur.
•
If a storage array is managed through more than one host, it is possible
that the storage array might become unresponsive to communication over
the connections given by one host. However, you might still be able to
manage the storage array over the connections provided by another host.
Recovering from an Unidentified Storage Array
Use the following procedure to recover from an unidentified storage array.
1 Make sure that the network connection to the storage management station
is operating.
2 Make sure that the controllers are installed and that the power is turned on
to the storage array. Correct any existing problems before continuing.
3 If you have an in-band storage array, use the following procedure. Click
Refresh after each step to check the results:
a
Make sure that the host-agent software is installed and running. If you
started the host before the host was connected to the controllers in
the storage array, the host-agent software will not be able to find the
controllers. If so, make sure that the connections are tight, and restart
the host-agent software.