Dell Inspiron Mini 12 (1210, Late 2008) - Manual (Page 11)

7. Lift the 2-in-1 memory and processor board out of its system board connector.
8. To replace the 2-in-1 memory and processor board, align the notch in the 2-in-1 memory and processor edge connector with the tab in the connector
slot.
9. Slide the 2-in-1 memory and processor board firmly into the slot at a 45- degree angle, and gently press the 2-in-1 memory and processor board down
until it clicks into place. If you do not hear the click, remove the module and reinstall it.
10. Replace the two M2x4-mm screws that secure the processor.
11. Replace the palm rest. See Replacing the Palm Rest .
12. Slide the battery into the battery bay, until it clicks into place and slide the battery-lock latch towards the lock position.
13. Update the BIOS using a flash BIOS-update program CD. See Flashing the BIOS ".
Back to Contents Page
NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in
damage to the computer.