Microprocessor module, Removing the microprocessor module – Dell Latitude 110L User Manual
Page 10
Back to Contents Page
Microprocessor Module
Dell™ Latitude™ 110L Service Manual
Removing the Microprocessor Module
Installing the Microprocessor Module
Removing the Microprocessor Module
1.
Follow the instructions in "
Before Working Inside Your Computer
."
2.
Remove the
keyboard
.
3.
Remove the
cooling fan
.
4.
Remove the
microprocessor thermal-cooling assembly
.
5.
To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
The ZIF-socket cam screw secures the microprocessor to the system board. Take note of the arrow on the ZIF-socket cam screw.
6.
Use a microprocessor extraction tool to remove the microprocessor module.
CAUTION:
Before performing the following procedures, read the safety instructions in the Product Information Guide.
CAUTION:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of
your computer's electronic components. You can do so by touching an unpainted metal surface.
NOTICE:
Press and hold the microprocessor down by applying slight pressure to the center of the microprocessor while turning the cam screw to
prevent intermittent contact between the cam screw and microprocessor.
NOTICE:
To avoid damage to the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor when turning the cam screw.
NOTICE:
When removing the microprocessor module, pull the module straight up. Be careful not to bend the pins on the microprocessor module.
1 ZIF-socket
2 microprocessor module
3 pin-1 corner of
microprocessor
4 ZIF-socket cam screw