Supported physical disks, Updating firmware – Dell PowerEdge VRTX User Manual
Page 5
Baseline v1 (Legacy): Single Shared PERC8 Configuration
Baseline
Shared
PERC
Firmware
Shared PERC
OS Driver
CMC
Firmware
Chassis
Infrastructure
Firmware
Expander
Firmware
Dual
Controller
Support
Microsoft Windows
Server 2012 R2
Not supported with this baseline
Microsoft Windows
Server 2012
23.8.2-0005 6.801.5.0
1.00
1.20
1.00
No
Microsoft Windows
Server 2008 R2
23.8.2-0005 6.801.5.0
1.00
1.20
1.00
No
Microsoft Windows
Server 2008
including Hyper-V
virtualization
23.8.2-0005 6.801.5.0
1.00
1.20
1.00
No
VMWare ESXi 5.5
Not supported with this baseline
VMware ESXi 5.1 U2 23.8.2-0005 06.801.52.00 1.00
1.20
1.00
No
VMware ESXi 5.1 U1 23.8.2-0005 06.801.52.00 1.00
1.20
1.00
No
SLES 11 SP3
Not supported with this baseline
RHEL 6.5
Not supported with this baseline
NOTE: The versions listed in the table are the minimum versions only.
Supported Physical Disks
It is recommended that you download and install the latest firmware on your system. For the latest
available physical disk firmware, see the Get drivers and downloads section of the product support page
at dell.com/support.
Updating firmware
You can update the PowerEdge VRTX enclosure and server modules installed in the enclosure by using
the following interfaces:
• Windows Dell Update Packages (DUPs)
• Integrated Dell Remote Access Controller (iDRAC web interface)
• PowerEdge VRTX Chassis Management Controller (CMC web interface)
• RACADM commands
The following are the prerequisites for updating the firmware:
• iDRAC web interface for each server module accessible from management station
5