CFM Corporation 3405BG - Manual (Page 8)

8
Assembly Step 4
Tools needed:
Hardware Bag
Locate these parts:
Burner Assembly
Phillips head
screwdriver
1/4-20 x 1/2” Bolts
3 required
B
Hardware:
1. Set the burner assembly onto the cabinet as shown. IMPORTANT:
The burner tube must slide properly onto the valve stem as shown
below.
2. Secure the burner assembly with the three (3) bolts from
inside the cabinet. Securely tighten the bolts.
3. Attach the loose ignitor wire to the ignitor on the control
panel as shown.