CFM Corporation 3405BG - Manual (Page 9)

9
����
��������������������
����
Assembly Step 5
Tools needed:
Hardware Bag
Locate these parts:
Phillips head
screwdriver
1/2” Wrench
10-24 Nuts
1 required
10-24 Lock Washers
1 required
10-24 x 5/8” Bolt
1 required
C
Hardware:
1. Turn the smoker upright.
2. Set the damper plate on top of the cabinet and align it
with the corresponding “butterfly” holes. One of the tabs
will seat inside one of the holes.
3. Insert a bolt from the top through the center hole.
4. From inside, place a lock washer and nut on the bolt.
5. Thread the nut just tight enough to keep the damper
plate snug. It should be able to rotate with little resis-
tance.
Bolt
Damper Plate
Lock Washer
Nut
Damper Plate
Cabinet Panel