Dell Vostro 500 (Mid 2009) - Manual (Page 22)

Back to Contents Page
Speaker Assembly
Dell™ 500 Service Manual
Removing the Speaker Assembly
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product
Information Guide.
1. Follow the instructions in Before You Begin .
2. Remove the center control cover (see Removing the Center Control Cover ).
3. Remove the keyboard (see Removing the Keyboard ).
4. Remove the Mini-Card (see Removing Mini-Card ).
5. Disconnect the speaker cable connector from the system board.
6. Remove the four screws securing the speaker assembly to the base of the computer.
7. Remove the speaker assembly.
1 screws (4) 2 speaker cable connector
3 speaker assembly
Replacing the Speaker Assembly
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product
Information Guide.
1. Align the guide holes in the speaker assembly with the guide posts on the base of the computer, then lower the
assembly into place.
2. Replace the four securing screws.
3. Route the speaker cables carefully through the routing channel.
4. Connect the speaker cable to the system board.