Dell Latitude E7440 (Mid 2013) - Manual (Page 41)

4. Perform the following steps as shown in the illustration:
a) Peel the LVDS cable connector tape [1].
b) Disconnect the LVDS cable from the display panel [2].
c) Remove the display panel from the display assembly [3].
Installing the Display Panel
1. Connect the display cable (LVDS cable) to its connector on the display panel.
2. Place the display panel to its original position on the display assembly.
3. Tighten the screws to secure the display panel to the display assembly.
4. Install:
a) display bezel
b) battery
5. Follow the procedures in After Working Inside Your Computer .
Removing the Camera
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a) battery
b) display bezel
c) display assembly
3. Disconnect the camera cable from the module. Lift and remove the camera from the display assembly.
41