Dell Studio 1536 (Mid 2008) - Manual (Page 14)

Back to Contents Page
Processor Thermal-Cooling Assembly
Dell™ Studio 1535/1536 Service Manual
Removing the Processor Thermal-Cooling Assembly
1. Follow the instructions in Before You Begin .
2. Turn the computer over and remove the base cover (see Removing the Base Cover ).
3. In sequential order (indicated on the thermal-cooling assembly), loosen the four captive screws on the thermal-cooling assembly processor cover.
4. Loosen the two captive screws on the thermal-cooling assembly sink.
5. Disconnect the thermal-cooling assembly fan cable from the connector on the system board.
6. Remove the screw from the thermal-cooling assembly fan and take out the thermal-cooling assembly.
Replacing the Processor Thermal-Cooling Assembly
1. Align the four captive screws on the processor thermal-cooling assembly processor cover with the screw holes on the system board and tighten the
screws in sequential order.
2. Tighten the two captive screws securing the thermal-cooling assembly sink to the system board.
3. Replace and tighten the screw to secure the thermal-cooling assembly fan to the system board.
4. Connect the thermal-cooling assembly fan cable to the system board.
5. Replace the base cover (see Replacing the Base Cover ).
Back to Contents Page
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1 thermal-cooling assembly sink 2 fan cable
3 thermal-cooling assembly processor cover 4 thermal-cooling assembly fan
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.