Dell E1910H Monitor - Manual (Page 24)

Back to Contents Page
Setting Up the Monitor
Dell™ E1910H Flat Panel Monitor User's Guide
Attaching the Stand
Connecting Your Monitor
Removing the Stand Base
Attaching the Dell Soundbar (Optional)
Removing the Stand for VESA wall mount
Attaching the Stand
Connecting Your Monitor
To connect your monitor to the computer:
1. Turn off your computer and disconnect the power cable.
2. Connect the blue display connector cable to the corresponding video port on the back of your computer.
Connecting the Blue VGA Cable
NOTE: The stand is detached when the monitor is shipped from the factory.
To attach the base of the stand to the monitor stand:
1. Place the monitor stand base on a stable table top.
2. Slide the monitor stand body in the correct direction down onto the back until it clicks into place.
CAUTION: Before you begin any of the procedures in this section, follow the Safety Instructions .