Replacing the display assembly, Procedure, Post-requisites – Dell Inspiron 17 (5749, Early 2015) User Manual
Page 76
Replacing the Display
Assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer
computer, follow the instructions in
. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
NOTE: These instructions are applicable only for laptops with a non-
touchscreen display.
1
Place the display assembly on the computer base and align the screw
holes on the display assembly with the screw holes on the computer
base.
2 Replace the screws that secure the display assembly to the computer
base.
3 Route the antenna cables through the routing guides on the computer
base.
4 Adhere the display cable to the fan.
5 Connect the display cable to the system board.
6 Adhere the tape that secures the display cable to the system board.
7
Close the display and turn the computer over.
8 Insert the antenna cables through the slot on the computer base.
9 Route the antenna cables on the computer base.
10 Connect the antenna cables to the wireless card.
Post-requisites
1
Replace the
.
2 Replace the
.
3 Follow the procedure from step 4 to step 5 in replacing the
4 Follow the procedure from step 3 to step 5 in replacing the
5 Replace the
76