Dell PowerVault 220S (SCSI) - Manual (Page 14)

1-12 Rack-to-Tower Conversion Guide
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m 2 From the front of the rack cabinet, press in on the blue release push button, grasp the
rail and lift up, and push the slide assembly back 2.54 centimeters (1 inch) away from
the front vertical rail until the mounting-bracket flange and its mounting hooks
disengage from the square holes in the front vertical rail (see Figure 1-6).
3 Repeat step 2 at the back of the cabinet for this mounting rail.
4 Repeat steps 1 through 3 for the remaining mounting rail on the other side of the rack.
5 Place the mounting rails and all fastener hardware in a box. Label the box as a rack
installation kit for the system model you removed from the rack.
This completes the procedure for removing the RapidRails mounting rails from a rack.
Removing the VersaRails Mounting Rails
1 At the front of the rack cabinet, remove the two 10-32 x 0.5-inch Phillips screws on
one of the VersaRails mounting-bracket flanges (see Figure 1-6).
2 Push back on the front mounting-flange bracket 2.54 centimeters (1 inch).
3 At the back of the rack cabinet, remove the two 10-32 x 0.5-inch Phillips screws that
secure the rear mounting-bracket flange to the rack’s vertical rail.
4 Repeat steps 1 through 3 for the remaining mounting rail on the other side of the rack.
5 Place the mounting rails and all fastener hardware in a box. Label the box as a rack
installation kit for the system model you removed from the rack.
This completes the procedure for removing the VersaRails mounting rails from a rack.
Replacing the Rack Doors
See the procedures for replacing doors in the documentation provided with your Dell rack
cabinets.
This completes the tower conversion of your system.
2H982bk1.book Page 12 Monday, November 5, 2001 10:12 AM