Removing the media card reader, Replacing the media card reader – Dell Studio XPS 9100 (Mid 2010) User Manual
Page 23
7.
Connect the power and data cables to the optical drive.
8.
If disconnected, connect the other end of the data cable to the system board connector (see
System Board Components
).
9.
Replace the front bezel (see
Replacing the Front Bezel
).
10.
Replace the computer cover (see
Replacing the Computer Cover
).
11.
Connect your computer and devices to electrical outlets, and turn them on.
12.
See the documentation that shipped with the drive for instructions on installing any software required for drive operation.
13.
Check the System Setup for drive configuration changes (see
System Setup
).
Removing the Media Card Reader
1.
Follow the instructions in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the front bezel (see
Removing the Front Bezel
).
4.
Remove the optical drive (see
).
5.
Remove the screw that secures the Media Card Reader to the chassis.
6.
Push and slide the Media Card Reader out through the front of the computer.
7.
Disconnect the power and data cables from the back of the Media Card Reader.
Replacing the Media Card Reader
1.
Follow the instructions in
Before You Begin
.
1
screw
2
data cable
3
power cable
4
Media Card Reader